Closed-Loop Geothermal Energy Recovery From Deep High Enthalpy Systems

Type:

Research Report

Links:

https://www.sciencedirect.com/science/article/pii/S0960148121008922

https://www.eavor.com/wp-content/uploads/2021/08/Science-Direct-Closed-loop-geothermal-energy-recovery-from-deep-high-enthalpy-systems.pdf

Author:

Wanju Yuan, Zhuoheng Chen, Stephen E. Grasby, Edward Little

Citation:

Yuan, W., Chen, Z., Grasby, S.E., Little, E. 2021. Renewable Energy, Volume 177, November 2021, Pages 976-991. https://doi.org/10.1016/j.renene.2021.06.028

Abstract:

Closed-loop geothermal energy recovery technology has advantages of being independent of reservoir fluid and permeability, experiencing less parasitic load from pumps, and being technologically ready and widely used for heat exchange in shallow geothermal systems. Commercial application of closed-loop geothermal technology to deep high-enthalpy systems is now feasible given advances in drilling technology. However, the technology it uses has been questioned due to differences in heat transport capacities of convective flow within the wellbores and conductive flux in the surrounding rock. Here we demonstrate that closed-loop geothermal systems can provide reasonable temperature and heat duty for over 30 years using multiple laterals when installed in a suitable geological setting. Through use of two analytical methods, our results indicate that the closed-loop geothermal system is sensitive to reservoir thermal conductivity that controls the level of outlet temperature and interference between wells over time. The residence time of the fluid in the horizontal section, calculated as a ratio of the lateral length to flow rate, dictates heat transport efficiency. A long vertical production section could cause large drops in fluid temperature in a single lateral production system, but such heat loss can be reduced significantly in a closed-loop system with multiple laterals.